Extrusion Processing Guide: PVC-P – Polyvinylchloride plasticised

1827
 Processing Guide: PVC-P – Polyvinylchloride plasticised
 Extruder: Single screw with vacuum, grooved feeding section
 Screw Design: 1) Two stage screw:
3:1 compression in feed zone (before vent)
decompression at the vent
3:1 compression (with at least 3-4 flights at the end of the screw as a metering zone)

2) Barrier screw

 Compression Ratio: 2,5-3,0:1
 Cylinder Temperatures: 140-190°C
284-374°F
 Melt Temperature: 170-200°C
338-392°F
 Pre-Drying: no
 Calibration:  
 Miscellaneous: material should be “cheesy” at the vent
Note: This is meant as a general guide. Please consult your material and machinery representative.

– Back to Overview

 

· ·


Related Articles & Comments

Comments are closed.